ok not profoundly of time left.. my adapter cord is broken fundamental the casing... (uh the box surrounded by the middle of the wire) if i twist around the nouns from the box to the computer i get it to charge... but after a few times of doing so it no longer works and i own no charging. um could i maybe solder the cable? or how can i fix the cable? PLEASE backing..
HELP computer ac adaptercord broken!!?? Quick Please!?
You give hugely little information Like Make and model
But I'll try
Try to take apart the outer layer If it has screw your in luck
DO NOTdo this near either wind up plugged in
See how the line is connecyed to the board.
You want to duplicate this if possible.
If not afterwards try to solder the cable
Cut approx 1/2 in from the diluted part strip rear legs the insulation and solder one wire at a time, remember what color chain went where on earth, then insulat beside electrical tape and tryout
If it works reassemble.
the best thing to do is only get another one it going to by better surrounded by the long run and cheaper to
If the box has any screw that you can take out, try that. Once inside, try to see if therre is any evidence of loose wires. If so, out of harm`s way the wire(s) by soldering or whatever plan necessary.
If within are no screws on the box, consequently you would be better off getting a strange cord. Try some of the second hand stores contained by your area, (Goodwill, Salvation Army). You might find lucky and find just the one that you requirement. Another option is to put a want hoarding on craigslist. The final option, and the most expensive is to establish a new one from the businessman of you computer.
how to curl hair with rollers
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment